Is it necessary to connect the CC1/CC2 pins to ground with a 5.1k resistor? I would like to make a pcb which has a female usb type c port which converts to
USB-C Programmable Power Supply For Any Project | Hackaday
USB Male A to Bare Wire 18" – Coolerguys
Amazon.com: XMSJSIY USB 2.0 Female Pigtail Cable Extension Power Cable 22AWG 5V 3A USB A Socket to 2 Pin Bare Wire Open End Connector for DIY-2 Pcs (0.3M) PLS Test The Neg
Amazon.com: FARSENSE USB DC 5V to 12V Step Up Power Cable(3ft), USB to DC 12V Adapter with DC Jack 5.5 x 2.5mm(3.5 x 1.35mm), USB Boost Converter Supports LED Indicator : Electronics
Does the resistor value on D+ and D- line matter on Arduinos? - Electrical Engineering Stack Exchange
4 pin PWM Fan to USB Cable Adapter 12"/30cm - Coolerguys
Amazon.com: Cablecc 5pcs/lot DIY 24pin USB Type C USB-C Male OTG Host Type 5.1k Resistor with Black Housing Cover : Cell Phones & Accessories